hogar
Phone Stand - Fully Printable
FreeCC BY-NC-SABeginnerPrintables
About this model
A desk stand for a phone in which every part is printed: no hardware and no magnets. It is a good first useful project after the calibration cube, because it prints fast and any first-layer defect shows up immediately on the base. CC BY-NC-SA licence: personal use and derivatives under the same licence, no commercial use.
Technical sheet
- Formats
- STL
- Category
- hogar
- Difficulty
- Beginner
- Estimated time
- —
- Suggested material
- pla · pla-plus · petg
- Supports
- —
- Printer type
- Filament (FDM)
- Verified on